Alto-Shaam 600-LVD/PT Instalación Funcionamiento y mantenimiento - Página 13
Navegue en línea o descargue pdf Instalación Funcionamiento y mantenimiento para Horno Alto-Shaam 600-LVD/PT. Alto-Shaam 600-LVD/PT 20 páginas. Hot food display cabinet, electric
Imprimir página
ERROR CODE DISPLAYS
Open-Circuited
If "000" is displayed in the Error Code
L.E.D., the sensor is open-circuited.
Follow Trouble Shooting Guide
instructions in this Operation and
Care Manual.
Short-Circuited
If "CCC" is displayed in the Error
I
HEAT
L.E.D.1
INDICATOR L.E.D.
Code L.E.D., the sensor is short-
circuited. Follow Trouble Shooting
CCC
Guide instructions in this Operation
and Care Manual.
!
ERROR
ERROR CODE
INDICATOR L.E.D.
CODE
DISPLAY
ERROR CODE INDICATOR L.E.D.
If either of the above mentioned errors
codes should occur, the Error Code
Indicator L.E.D. will be illuminated and
remain so until error is cleared.
CAUTION
The unit should be unplugged and a qualified
service technician should be consulted if any of
the following situations occur:
• The Heat Indicator L.E.D. does not
illuminate after normal start-up.
• The warming cabinet does not hold
the temperature as set.
• The warming cabinet fails to heat with the L.E.D.
illuminated.
• The cabinet heats continuously with the
control "OFF".
Refer to Trouble Shooting Guide in this manual.
√
S E R V I C E
ELECTRONIC CONTROL ACCURACY
®
The electronic control is a precise instrument and is
designed to offer trouble-free service. If you suspect
the temperature inside the warming cabinet does not
match the temperature indicated on the digital dis-
play, after stabilizing, follow the instructions
listed below.
1. Make certain the power meets the requirements
of the appliance, voltage and current rating as
indicated on identification tag.
2. Verify the temperature inside the warming cabi-
net with a quality thermal indicator (digital).
A. With the exception of the metal shelves,
C. Suspend the thermal indicator in the center
DO NOT OPEN THE CABINET DOOR(S) DURING
THE TEMPERATURE STABILIZATION PERIOD.
If the reading on the thermal indicator does not
match the digital display, there may be a problem
with the air sensor. See troubleshooting guide in this
manual; or call the factory service department for
advice.
# 8 2 4 O p e r a t i o n a n d C a r e M a n u a l • 12.
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION.
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
completely empty the warming cabinet.
B.
Make certain the sensor, located inside
the warming cabinet at the ceiling, is
completely clean.
of the warming cabinet.
D. Allow the temperature, set on the electronic
thermostat, to stabilize for a minimum of one
hour before comparing the digital display
with the reading on the thermal indicator.
TO AVOID BURNS,