AkitikA VC102 Manual de montaje - Página 5

Navegue en línea o descargue pdf Manual de montaje para Amplificador AkitikA VC102. AkitikA VC102 9 páginas. Volume control kit

work. Taking it easy will prevent you from damaging the chassis, or yourself, or

turning the chassis into a propeller, or poking big holes in the duct-tape catch basin.

Finally, drill the hole out to the finished 5/16" diameter.

Remove the duct-tape catch basin. If you "smush" it against the inside of the chassis front

wall, you may find it catches most of the metal shavings. De-burr the edges of the hole.

Remove the masking tape that you used to mark the hole location.

When to Install the Volume Control

We recommend that you assemble and test the amp in the normal fashion before you

install the volume control. That will allow you to separate problems that might arise

during amplifier assembly from problems that might arise during volume control

installation.

Prepare two lengths of shielded cable

 A 7.5" length for the right channel, and

 A 12" length for the left channel

Use the directions in the Appendix.

Make sure to reserve the removed outer insulation, as you'll use this to insulate the drain

wire of the shielded cable. Figure 2 shows the connections.

Figure 3 shows an example of the completed assembly at the volume control end.

I've made these lengths somewhat longer than necessary to make it easy to remove a module if

troubleshooting is necessary.

Page 5 of 9