3dsimo MultiPro Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica 3dsimo MultiPro. 3dsimo MultiPro 12 páginas. Multifunctional tool for workshops and households
También para 3dsimo MultiPro: Instrucciones de uso (2 páginas)
Imprimir página
Maintenance
3D drawing attachment
Make sure the filament is not warped,
has both ends cut off, and is not rolled
up too tight.
Before completing the 3D drawing
ALWAYS eject the filament completely
out of the tool body, otherwise the nozzle
may be damaged. Store filament in a
closable bag.
In case of heavier soiling, the nozzle can
be cleaned with paper towels when it is
fully heated - CAUTION HOT!
Burning and soldering attachment
The accessory can be cleaned with towel
paper, never use sharp, hard or abrasive
tools!
This will damage the special layer on the
surface and cause unwanted behaviour
of extension.
In case of wear, the extensions can
be replaced by spare parts, available
in the 3Dsimo online store. Unscrew
the extension counterclockwise. The
tightening of the extension tip should
be done with sensitivity and without
use of tools.
Resistance wire cutting extension
Contamination of the wire can be
removed with a paper towel.
If the resistance wire breaks, always use
a new wire, available in the 3Dsimo
online store.
Check that the ventilator is running
smoothly. If you see dirt adhering,
remove it with tweezers.
To remove filament residue, push another piece
of filament through the body of the pen without
the extension attached.
Gently clean the contacts of all
attachements with a dry cloth.