Camina Art Moderne Instrucciones de uso y montaje - Página 4
Navegue en línea o descargue pdf Instrucciones de uso y montaje para Estufa de leña Camina Art Moderne. Camina Art Moderne 12 páginas.
Imprimir página
General
In order to avoid condensation, insula-
tion material should be inserted over the
connection hose. The next stage is to fit
the log-compartment plates (see photo
below).
Fitting the log-compartment plates.
The sopestone-base unit, and the cast-
iron base unit, which are optional extras,
increases the connection height by 40 mm
(see illustrations for the various models).
Available for Camina Art Grace and
Camina Art Etage.
4
Manufacturer' s assurance
This product has been manufactured in accordance with the type approval documenta-
tion, of which the instructions for assembly, use and maintenance form an intrinsic part.
Before commencing a new installation of a stove and chimney in an area covered by
town planning, you must notify the local planning authority. The planning and building
office in your local municipality will provide further information.
When installation has been completed, it must always be inspected by a chimney sweep
before the stove is used, irrespective of whether it is connected to a new or an existing
chimney.
Before using your stove, you should read the terms of the guarantee (see our website
and/or the inside cover of our product catalogue), indicating the requirements that must
be met if the guarantee undertakings are to apply.
The diameter of the flue must be at least 150 mm, and we recommend a inimum flue
height of 3.5 metres, measured from the stove flue-connection point. Follow the chimney
supplier's assembly instructions carefully.
If you intend to fit your stove to an existing masonry chimney, it should first be inspected
by a chimney sweep to check that it is in good order.
The stove can be connected at either a 45
cleaning door, to a chimney approved for a maximum flue-gas temperature of 350
Distance from combustible wall surfaces
The minimum distance from a combustible wall surface is 500 mm at the sides and 100
mm at the rear (see diagrammes on page 9). The minimum distance from furnishings in
front of the stove is 1000 mm. If the stove is placed against a masonry chimney or a fire-
wall installation, the space behind the stove may be reduced to 50 mm.
A stove with a chimney does not normally require special foundations, and can be pla-
ced on an ordinary floor supported by wooden rafters. If you are uncertain, contact a
chimney sweep for further advice and instructions.
The stove must be placed on a fireplace base consisting of concrete, natural stone, brick
or glass with a thickness of at least 50 mm, or sheet metal with a thickness of 0.7 mm.
The base must cover the entire surface under the stove and extend at least 300 mm in
front of the stove and 100 mm at the sides. A fireplace base in sheet metal or glass is
available as an optional extra.
The delivery includes the stove and inserts for a top or rear connection. Options include a
fireplace base and a connection kit for an existing chimney. An outside air-feed connec-
tion and a fan are also offered as optional extras.
Planning application
Inspection
Guarantee
Chimney
angle, or at a 90
0
Load-bearing structure
Fireplace base
What is included?
angle, straight-back with a
0
C.
0