esera automation 11218 Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Sistemas de E/S esera automation 11218. esera automation 11218 7 páginas. Binary output / dual switching module for 1-wire bus system
Imprimir páginaFunction button 1 Module top side
Briefly press button: Switching the output relay
Press button for 2 seconds: Changing energy mode on/off
Power saving mode on: LED1 flashes twice briefly
Normal operation mode: LED1 lights up for 2 seconds
Function button 2 Module top side
Briefly press button: Switching output relay
4
Technical data
Switching channels:
Switching voltage:
Switching power/Power: maximum 10A continuous current, maximum 2200VA continuous current at Ohm
Fuses:
Data interface:
1-Wire component:
Supply voltage:
Power consumption 12V:Idle mode, no output relay active: approx..6mA
Button interface:
Connection:
5
Ambient conditions:
Temperature, operation: 0 °C up to +50 °C
Air humidity:
Measurements:
Protection class:
Protection type:
Insulation strength:
6
Connection plan
Connection plan is available in the webshop
as own document
Note: A back-up fuse of 10A must be
provided before terminals 8 and 11
6.1 Option: Changeover relay, switch
Connection Top side:
7 = Relay 1, normally open contact / NO
8 = Relay 1, input
9 = Relay 1, normally closed contact / NC
10 = Relay 2, normally closed contact / NC
11 = Relay 2, input
12 = Relay 2, normally open contact / NO
1-Wire Bus
Module bottom side:
1 = GND (ground)
2 = 1-Wire data line
3 = +12V power
4 = GND (ground)
5 = Button interface 1 external
6 = Button interface 2 external
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
2, changeover relay (NO and NC contact)
maximum 250V direct power voltage or alternative power voltage
resistive load. minimum load 10mA
In case of capacitive or inductive loads, appropriate additional wirings, e.g. spark
suppressor capacitors must be considered. Maximum power and output will be reduced.
External preliminary fuse with 10A recommended
1-Wire Bus (12V, data and ground),
DS2413 (Dual I/O)
12VDC (+/-10 %)
Both output relays are active: approx. 75mA in normal mode, approx. 38mA in
energy-saving mode
2, input for button (make contact), no external power allowed
Screw terminals (up to 2,5qmm wire cross section)
10 – 92 % (non-condensing)
35 x 90 x 70mm (WxHxD)
II
IP20
500VAC output to 1-Wire Bus, 250VAC output to output
11218 V2.0 R1.0 Manual
Page 2 of 7