3DUpFitters Prusa i3 MK3 Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Impresoras 3D 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 11 páginas. Enclosure kit
También para 3DUpFitters Prusa i3 MK3: Manual de instalación (18 páginas)

Imprimir página

Assemble Panels

1. The Front Door

Each of the corners on the enclosure will be held together by the connectors pictured below. There are

only two versions L and R, which can be identiﬁed by the letters stamped on the inside. The opposite

connectors are identical, i.e. Bottom Right is the same as Top Left. In all cases the surface of the

connector with the cutout pattern faces front or back. Note the pictures below show the back of the

front panel.

Top Left

Bottom Left

The front door is designed so that the latch is on the left.

Attach the corner connectors on the back side of the

door frame using the provided cap head 12mm screws.

See the photos above. The top of the connector should

be ﬂush with the top of the acrylic. Adjust the screws

snugly, but not tight as you'll adjust them later.

Top Right

Bottom Right