Division 6 Dual Mini Instrucciones de construcción - Página 2

Navegue en línea o descargue pdf Instrucciones de construcción para Sintetizador Division 6 Dual Mini. Division 6 Dual Mini 4 páginas.

Install Regulator

Insert VR1 into the board, making sure the flat side of the part is lined up with

the flat side on the silkscreen pattern. Solder and trim the leads.

Install Electrolytic Capacitors

Insert C1, C2, C7, and C8 into the board. Polarity does matter for electrolyt-

ics, so make sure the (-) stripe is lined up with the - (round) hole on the PCB

(and is opposite the "+" marking on the silkscreen pattern). Solder the

capacitors into place and trim the leads.

Install Power Connector

Insert P3 into the board, aligning the notch in the connector with the notch

indicated on the silkscreen pattern. Make sure the connector is flat against the

board, then solder it into place. The pins are short enough that they don't

need to be trimmed.

Dual Mini Synthesizer Build Instructions

Flip the board over! From here on out, all the parts go on the other side

Install LEDs

Slip an LED spacer onto each LED D1-8.

Insert the LEDs into the PCB and bend the pins outward to hold the LEDs into

place. Polarity does matter for LEDs; you'll notice that they all have a flat

side on their package. If the flat side is hard to see, each LED also has a long

and a short pin to indicate polarity.

It doesn't really matter which color you put where, but the LEDs in your kit

were chosen with the following layout in mind:

You may want to temporarily fit the front panel in place to make sure all the

LEDs are straight and line up with the LED holes in the panel. Solder and trim

the leads.

Page 2/4

FLAT SIDE = SHORT PIN = NEGATIVE (-) = SQUARE PAD ON PCB