Division 6 Dual Mini Sequencer Manual de instrucciones - Página 13

Navegue en línea o descargue pdf Manual de instrucciones para Sintetizador Division 6 Dual Mini Sequencer. Division 6 Dual Mini Sequencer 14 páginas.

If you use the RUN button to pause the sequencer then start it again, whatever transpose

amount you set will be retained. If you press RESET to go back to the beginning of the

sequence then the transpose amount will be cleared.

There are a few other buttons that work in LIVE TRANSPOSE mode that might come in handy

during a live performance:

REST: Makes the next step a REST (one time only)

•

LOOP: Loops back to the beginning of the song or sequence on the next step (one time

•

only)

ACC: Turns on ACC OUT on the next step (one time only)

•

LIVE EDIT

Normally when a sequence is running, the NOTE buttons don't do anything. With LIVE EDIT

mode enabled, you can use the NOTE buttons to program your sequence on the fly.

To enable or disable LIVE EDIT mode, hold PROG/RESET down and tap the ACC button. The ACC

LED will blink twice for enabled and flicker dimly for disabled.

When the sequencer is running, pressing a NOTE button will program that note into the current

step. You can also program a REST or a LOOP during live editing.

Note: the changes you make using LIVE EDIT don't actually get written to the sequencer's non-

volatile memory until you pause/stop the sequencer. Don't disconnect power while it's running

or you'll lose your changes! (This does not apply to using the normal PROGRAM mode; changes

are saved immediately.)

1X mode is enabled by default, and is the way the v1 firmware worked.

Normally the sequencer sends a pulse from XP OUT to XP IN (the jacks are normalled) when it

falls off the end of a sequence and it's time to loop. This is so you can daisy-chain to/from other

sequencers. If you plug something into XP IN that interrupts this signal, then the sequencer will

just pause when it gets to the end of a sequence.

In order for you to be able to use XP IN as a reset input without the need for an external gate

mixer, you can disable 1X mode. Hold PROG/RESET down and tap the RUN button. The RUN

LED will flicker dimly for disabled and blink twice for enabled.