3e Technologies International 3e-250 Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Adaptador 3e Technologies International 3e-250. 3e Technologies International 3e-250 18 páginas. Bluetooth to rs-232 cordless adaptor

Imprimir página

At this point, you have completed the communication setup between

the 3e-250 Adapter and the other Bluetooth device.

To verify the connection, type some characters in the Hyper Terminal

window on one of the computers. The same characters should be visible

in the Hyper Terminal window on the other computer. Whole files can be

transferred using the Transfer à Send File option in the Hyper Terminal

window.

Connecting to a Test Instrument

Connecting to a test instrument can be a bit more complex than con-

necting from PC to PC, because you will need to know the RS-232 signals

supported by the particular instrument. Each test instrument has its own

mechanism which that instrument uses for hardware flow control (RTS/

CTS and DTR/DSR).

Before installing the 3e-250 Adapter on a test device, research the

required settings for that test device in its documentation.

The 3e-250 Adapter has two dipswitch settings accessible on the back

(bottom) of the device.

The dipswitches allow you to configure for the particular device.

The DTR/DSR switch is set to the ON position by default. The RTS/CTS

switch is set OFF by default.

Once you have configured the dipswitches, connect the 3e-250 to

the DB9 connector on the test instrument. If there is not enough space to

directly connect to the DB9 connector, use a 9-pin straight cable with a

male connector at one end and a female connector at the other. (This is not

included in the install kit.)

You can now communicate to the 3e-250 from the Bluetooth device on

the host PC.

Using the LEDs

There are three LEDs on the 3e-250.

• Bluetooth Link Activity Indicator

• Battery Status Indicator

• Battery Charging Indicator

User's Guide