ClearMirror BigSexy 16105-306024M Manual de instrucciones de instalación - Página 2
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Mobiliario interior ClearMirror BigSexy 16105-306024M. ClearMirror BigSexy 16105-306024M 7 páginas. Showerlite led back-lit, fog-free shower mirrors
Imprimir páginaNOTICE: All installation wiring must be performed by a licensed electrician. Follow the National
Electrical Code, local codes, NFPA 70-2011 as applicable.
NOTICE: Only use the power supply included with this product.
NOTICE: All wiring including new receptacles, must be performed by a licensed electrician.
Follow the National Electrical Code or local codes as applicable.
WARNING: Power supply must be placed in a dry location outside of the shower and must be
at least three feet from the shower. Follow NEC Article 406. Failure to follow instructions could
result in death or serious injury.
General Guidelines
• Extreme caution is necessary when any heater is used by or near children or invalids and
whenever the heater is left operating and unattended.
• Do not operate any heater after it malfunctions. Disconnect power at service and have heater
inspected by a reputable electrician before reusing.
• Do not use outdoors.
• To disconnect heater, turn controls to off using light/fan/receptacle switch, and turn power off to
circuit at the main disconnect panel.
• Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
• Do not install on uninsulated exterior walls in cold climate areas.
• Do not install if product is damaged.
• Do not bend, cut, alter, submerge in water, or use for purposes other than described.
• Mirror must be caulked or grouted into tile, flush with the tile surface. Edges of the mirror cannot
be exposed to touch.
• Contact ClearMirror for LED replacement parts.
• Consult the NEC, Article 551 for recreational vehicle installation.
• SAVE THESE INSTRUCTIONS.
Installation
Activate the Big Sexy ClearMirror by a switch. You may decide to connect it to another light or fan to
ensure it is turned off when not in use.
1. Before installing wall tile, measure for desired mirror height from the finished shower floor.
2. Prepare an area 30" x 60" for the mirror (or custom size). Adjust for your grout lines.
3. Measure and mark the location of the junction box for the heater leads. Typically centered.
4. Measure & mark the location of the LED light.
5. Remove the marked area of wallboard to allow the mirror to install flush with the tile and run the
LED lead to the location of the LED Power Breakout.
6. Remove the marked area of wallboard and mount the junction box per manufacturers
instructions. (see Figure 1).