ESi Ergo VICTORY 2VT-C36-30 Series Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior ESi Ergo VICTORY 2VT-C36-30 Series. ESi Ergo VICTORY 2VT-C36-30 Series 8 páginas. 2 leg electric table base

Imprimir página

VICTORY 2 LEG ELECTRIC TABLE BASE

Setting

Memory

Button

Buttons

GENERAL OPERATION

Move the table up or down by pressing UP s or DOWN t until

the work surface reaches the desired height.

The table will continue to move up or down until you release the

button or until the maximum or minimum height is reached.

MINIMUM AND MAXIMUM STOP POSITION

This feature can be used to limit the range of table travel to

prevent the work surface from hitting items below or above it.

• The minimum stop position must be in the lower half of the

movement range, and the maximum stop position must be in

the upper half.

• Minimum and maximum stop positions must be set separately.

To set a stop position:

• Move the work surface to the desired minimum or maximum

height.

• Press and hold both the UP s and DOWN t buttons for 10 to 15

seconds. The control unit will click twice when the stop position

has been stored.

To erase a stop position:

• Move the work surface to the stop position to be erased.

• Press and hold both the UP s and DOWN t buttons for 10 to 15

seconds. The control unit will click once when the stop position

has been erased.

SAVING A TABLE POSITION

The three memory buttons can be used to save specific positions

of the work surface. To set a specific position:

• Adjust the work surface to the position you want to save. (The

display on the control pad shows the work surface height.)

• Press the Setting button S. The display will read S – –.

• Press the desired Memory button, 1, 2 or 3. Let's say you

pressed 1. The display will read S1.

• The work surface position is now saved. The control unit will

click twice after about two seconds and the display will show

the work surface height.

Table

DOWN

Height

Button

CAUTION: The "zero setting" procedure

must be completed before operating the

table. See Step 12 on page 5.

Table movement stops when you

release the UP s or DOWN t button.

You can set a minimum stop, a

maximum stop, or both a minimum

and maximum stop.

Minimum and maximum stops can

serve the same function as memory

stops. For example, minimum stop

could be the user's standard sitting

position and maximum stop could

be the user's standard standing

position.

Default stop position for the three

memory buttons is the lowest height

of the work surface.

OPERATION