Akiyama MC-Club Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Mezclador de música Akiyama MC-Club. Akiyama MC-Club 12 páginas. 19 inch 5 channel

Imprimir página

FUNCTIONS

Front Panel

THE CHANNEL

1.-Input assign switches: These switches allow to choose which

of the following backpanel inputs will be audible:

Phono (turntable MM cartridge) or CD or Line (CD and Line

inputs are same characteristics)

2.-Gain Control: Allows the adjustment of the channel input

sensitivity regarding the different source levels. Each channel

has an optical check up by means of the 10 LED bargraphs of the

level meter.

3.-Channel EQ: Independent control is provided for the high

(13KHz), the mid (1KHz) and the low (70Hz) frequency band.

Please be aware, that any boosted frequency band will increase

the total level and decrease the level headroom.

4.-Channel level meter: The meter displays the channel level

before channel fader. To set the channel at the right level, when

in play back, set the Gain in a way that all green Leds light and

the yellow and red only blink.

5.-Headphones assign switch (Cue): With these switches you

can assign any of the input channels to be replayed on the

headphones. Please note that you can only hear the required

source if the input assign switch is switched to the respective

position and the source is in play mode.

6.-Channel fader: By means of these controls, you determine

the part of the overall level, that a specific channel contributes.

Please be aware of the final output level to be adjusted by the

Master and Booth controls.

To be in-field replaceable, this part is front-detachable. For

replacement, switch off the unit and unscrew the 4 outer screws

of the panel and remove it; unscrew the 2 screws that hold the

fader and replace it. Plug in the connector and screw the new part

to the main body again.

THE MAIN MIC CHANNEL AND TALKOVER (CH-5)

This originally Main Microphone intended channel can be turn

mc club

into a normal stereo channel by means of the input assign switch.

However it bears some typical Mic channel format.

7.-Microphone equalizer: only High and Low level tone

controls are available.

8.-

Channel 5 Level differently from the other channels

Channel 5 Level is a rotary knob instead of a fader.

9 Talkover engage

: When TALKOVER is selected, all signals

except the Main microphone level are decreased, The amount of

signal reduction is adjusted by the control (10).

10 Talkover

level: It determines the degree of sound level

reduction when Talkover engaged.

.-Cue: It is an standard Cue function as seen on the remaining

channels.

12 Main Mic connection It is a symmetric connection. Use a

Jack TRS.

MASTER AND MONITOR SECTION

13.-Main LED bars: The level meter bargraphs shows the

stereo output level of Master output when Monitor Selector (14)

in Master mode. When Monitor Selector selector in Cue mode

the left bargraph will show Cue level and the right bargraph will

depict Master (PGM) level.

14.-Monitor Selector: See point 13.

15.-Master level control & Balance: Controls independently

from Booth an external amplifier (main amplifier). The signal's

stereo balance can be controlled by means of control Balance

Master (bal). This signal is displayed on the level meter.