Alton STANLEY Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Aspiradora Alton STANLEY. Alton STANLEY 14 páginas. 23 litre wet/dry vacuum

Imprimir página

CARE AND MAINTENANCE

FILTER REPLACEMENT

WARNING: To reduce the risk of injury from accidental starting, unplug power cord before

changing or cleaning filter.

The filter should be cleaned often to maintain peak vac performance.

IMPORTANT: To avoid damage to the blower wheel and motor, always reinstall the reusable filter

before using the vac for dry pickups and always reinstall the foam filter before using the vac for

wet pickups.

IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a filter with holes or

tears in it. Even a small hole can cause a lot of dust to come out of the vac. Replace it immediately.

NOTE: Before installing the filter on the vac, clean the area of the lid so that the clamp ring will seal

the bag against the lid and stop small particles from bypassing the filter bag.

If the filter is clean and not damaged, replace it on the filter cage. If it cannot be reused, place a new

filter over the filter cage.

NOTE:

Clean the filter in an open area. Cleaning should be done outdoors and not in living quarters.

WARNING: Do not remove filter cage and float. The float prevents water from entering the

impeller and damaging the motor. The cage prevents fingers from touching the moving impeller.

CLEANING

To keep the wet/dry vac looking its best, clean the outside with a cloth dampened with warm water

and mild soap.

To clean the tank:

1. Dump out debris.

2. Wash tank thoroughly with warm water and mild soap.

3. Wipe out with dry cloth.

STORAGE

Before storing the vac, the dust tank should be emptied and cleaned. The cord should be wrapped

and hung on the unit and the accessories should be kept in the accessory holder so they can be

readily available. The vac should be stored indoors.

TROUBLESHOOTING

WARNING!

TO REDUCE THE RISK OF INJURY FROM MOVING PARTS AND/OR ELECTRICAL SHOCK,

TURN POWER SWITCH OFF AND DISCONNECT GROUNDED PLUG FROM ELECTRICAL

OUTLET BEFORE PERFORMING TROUBLESHOOTING CHECKS.

Minor problems often can be fixed without calling customer service.

PROBLEM

Vacuum will not run

Loss of suction,

wet pick-up

Loss of suction, dry

pick-up

POSSIBLE CAUSE

No electricity

1. Full tank

2. Clogged hose

3. Clogged filter

1. Full tank

2. Clogged hose

3. Clogged filter

CORRECTIVE ACTION

Make sure electrical outlet has voltage

(A qualified electrician may need to be contacted)

1. Drain and clean tank

2. Remove hose and clean debris

3. Clean or replace filter

1. Drain and clean tank

2. Remove hose and clean debris

3. Clean or replace filter