Dixon Bayco DBC Series Instrucciones de mantenimiento y funcionamiento - Página 5
Navegue en línea o descargue pdf Instrucciones de mantenimiento y funcionamiento para Equipamiento industrial Dixon Bayco DBC Series. Dixon Bayco DBC Series 13 páginas. 3" dry disconnects
Imprimir páginae. If you are unable for any reason to remove the SEAL
CYLINDER, depress the SEAL CYLINDER back into the
BODY and re-secure the BLANK ADAPTER using the CAM
ARMS. Never allow a partially disassembled unit to remain
unattended. The SEAL CYLINDER could be ejected from the
body unexpectedly and cause injury.
7. Remove the SEAL CYLINDER and SPRING from the BODY. If you
are repairing the SEAL CYLINDER NOSE SEAL, discard the SEAL
CYLINDER if it has a molded on NOSE SEAL. If the NOSE SEAL is a
separate PTFE piece, then just the PTFE NOSE SEAL needs to be
discarded.
8. Remove and discard the BUSHING inside of the SEAL CYLINDER
if it is worn and is being replaced. Remove and discard the guide
BUTTONS on the outside of the SEAL CYLINDER if they need to be
replaced.
9. Remove the O-RING in the BODY that seals the SEAL CYLINDER
if it is being replaced. A small brass hook may be used to extract this
seal. Take care not to scratch the sealing surfaces inside of the O-
RING groove or the SEAL CYLINDER bore.
10. Remove the spring seat WASHER from the body. Keep this part
for reuse.
11. Remove the COTTER PIN from the main SHAFT and discard.
This COTTER PIN is located between the YOKE and BODY.
12. Remove the LEVER from the main SHAFT. It may be necessary
to gently pry the LEVER from the CAM SHAFT using the blade of a
screwdriver. It may also be helpful to insert the blade of a screwdriver
into the slot of the LEVER to spread the LEVER open.
13. Unthread the STUFFING BOX from the BODY. Take care not to
scratch the sealing surfaces inside of the STUFFING BOX.
14. You may remove and discard the O-RING on the STUFFING
BOX as well as the BEARING if these are items that are being
replaced due to wear. The BEARING is pressed in place so you will
need to use a pin with shoulder to remove the BEARING.
15. Remove the main SHAFT from the BODY by sliding it out from
the YOKE.
16. Remove the Yoke and POPPET STEM from the body.
DBC 3" SERIES
DBC 3" Series Dry Disconnects
877.582.3569
5