ClearSpan PB02000R4N Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Tienda ClearSpan PB02000R4N. ClearSpan PB02000R4N 13 páginas. Round style mini garage
Imprimir páginaNOTE: Tek screws are self-drilling and no pilot hole is
usually required. If you have trouble getting a Tek screw
to "bite", try another Tek screw (or you can drill a 3/16"
pilot hole).
6. On the sides of the rafter, position the top strap of
the end clamp to rest on the Tek screw as shown in
Figure 4. This prevents the clamp from slipping
when the purlin supports any weight.
Rafter
Outside of
shelter
Purlin
Figure 4. End Clamp Resting on Tek Screw
7. Slide two purlin end clamps on bottom side of each
end rafter into the positions at least 2-4" away from
the rafter bottom, as shown in Figure 6, to leave
room for the short tee connector added later.
8. Slip five cross connectors over each inside rafter at
the same end clamp positions shown in Figure 2.
9. Leave screws loose on the cross connectors so you
can slide in the purlins later.
10. On the sides of the rafter, position the top strap of
the cross connectors to rest on the Tek screw as
shown in Figure 7. This prevents the clamp from
slipping when the purlin supports any weight.
ASSEMBLE THE FRAME
Gather the Parts
•
All Rafter Assemblies
•
Pipe 1.315"x75" Swaged 17GA (10) (#131S075)
•
Pipe 1.315"x73.5" Plain 17GA (5) (#131P0735)
•
Strut 5' (4) (#QH1304)
•
Band Clamps (4) (#QH1400)
Assembly Procedure
1. Stand one end rafter (one with the band clamps
attached) and brace it in place as shown in
Figure 5. Check that the rafter is standing up
Visit www.ClearSpan.com for additional products and customer assistance.
End clamp
Tek screw
Outside of
shelter
2. Insert the plain ends of 75" purlin pipes into the end
! CAUTION: To prevent cover damage, the ends of the
purlins should extend no more than ½" past the end
clamp. The bolt side of the end clamps must go toward
the "inside" of the shelter (the same side as the purlin)
as shown in Figure 6.
3. Position an inside rafter from the end rafter using an
4. Slide a purlin through cross connector at the top of
Connector
straight (plumb). Position the bolt side of end clamp
to the inside of the frame.
Figure 5. Standing Rafters
purlin clamps at the bottoms of the end rafter and
tighten the clamps.
½"
2-4"
Figure 6. Purlin Inserted into End Clamp
on-center rafter-to-rafter spacing of 43 ¼". Have
your partner hold the rafter in position while you
tighten the cross connectors at the bottom of the
second rafter.
second rafter and also through the end clamp at the
top of the end rafter. Verify that the rafter is properly
spaced and plumb and tighten the cross connector
nd
at the top of the 2
rafter.
Cross
Tek
Screw
Figure 7. Cross Connector Assembly
Inside of
shelter
Rafter
Purlin
5 of 12