ClearSpan R035B00011B Manual - Página 12
Navegue en línea o descargue pdf Manual para Kit de invernadero ClearSpan R035B00011B. ClearSpan R035B00011B 15 páginas. Greenhouse door kits
Imprimir páginaDoubLe CoRRuGATeD DooR ASSeMbLY (continued)
13.
Attach the 6" chain bolt to the inside, upper corner of
the door without the handle (see X in drawing below).
Mount the latching plate to the outside of the same
door (see drawing in step 12). The screws supplied
with the latch are not used for metal jambs.
X
Door
without
handle.
Inside
View
14.
At the top and sides of the end wall door opening
on the inside of the frame, attach end cap and allow
it to extend below and into the door frame opening.
Consult the photos below.
Door Jamb
12
Corrugated Double Swinging Doors
outside
View
End Cap
(#104548)
The installed
polycarbonate end
wall panels have
been removed to
better show the
door jamb.
Step 14c
Step 15
Ground Level
ATTeNTIoN: This profile acts as a stop for the
double doors, which prevents undo stress on the
hinges.
a.
Photos show the end cap as attached to the end
wall door jamb. View shows the assembly from
the outside.
b.
Cross section insert shows the end cap (dashed
line) attached to the inside/back of the door jamb.
c.
Dashed line below identifies where to attach the
end cap profile. The end cap extends beyond
the frame members and into the rough opening
to stop the door in the frame and to help seal the
gap between the door and frame.
15.
After end cap profile is installed, install another
section of the same end cap on the inside frame of
the door that includes the chain latch.
NoTe: This length of end cap will act as a stop for
the remaining door of the double door assembly
when both doors are closed.
16.
Check the operation of the latches and the doors.
17.
After installing the door to the frame, read the care
and maintenance section.
Step 14c
End cap used for door stop
and seal.
Revision date: 05.28.10