Altrad Belle RTX 80D Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica Altrad Belle RTX 80D. Altrad Belle RTX 80D 15 páginas.

CAUTION

Improper operation can be hazardous. Read and understand this section before you start the machine.

WARNING

immediately stop the machine from vibrating.

Honda GX100, GX120 & GXR120

2. Set the speed control lever to the STARTING position (Halfway between HIGH and LOW

3. Move the choke lever to the CLOSED position.

9. Allow the engine run at idle for a few minutes to warm up.

11. Move the throttle lever to the high speed position quickly to prevent damage from occuring to the clutch. The 'Full Throttle' position

of this machine has been preset at the factory to achieve optimum machine performance.

14. Allow the engine to idle for 1-3 minutes.

15. Push and hold the RED Engine Stop button.

17. Pull the recoil starter slowly until you feel resistance. Then release your hand from the starter knob to set it back to its

original position. This will prevent any air or humidity from entering into the cylinder.

Yanmar L48

1. Slide the Engine Speed Control Lever to the RUN position.

3. Push the decompression lever down and release it. The decompression lever will automatically return to the original position when

the engine starts.

CAUTION

the oil port and reinsert the oil plug.

6. Allow the engine run at idle for a few minutes to warm up.

8. Move the throttle lever to the high speed position quickly to prevent damage from occuring to the clutch. The 'Full Throttle' position

of this machine has been preset at the factory to achieve optimum machine performance.

11. Allow the engine to idle for 1-3 minutes.

Start & Stop Procedure

OPEN position.

LOW position.

STOP position