DiyTracker REAL TIME GPS TRACKING ANDMONITORING SYSTEM Manual del usuario Instrucciones de instalación y funcionamiento - Página 5

Navegue en línea o descargue pdf Manual del usuario Instrucciones de instalación y funcionamiento para GPS DiyTracker REAL TIME GPS TRACKING ANDMONITORING SYSTEM. DiyTracker REAL TIME GPS TRACKING ANDMONITORING SYSTEM 15 páginas.

Imprimir página
Diagram
Wiring
Wire
Description
Power
Digital Output
Digtal Input
Microphone
RF Receiver
Antenna
Power cut relay
(Optional connection)
This connection is to remotely immobilise your vehicle. Please be cautious if installing
this optional immobiliser function as large currents are carried when starting a motorcycle
and we would hate for you to have an unplanned stop due to an installation failure.
A.
Connect Pin6 grey wire/cable to the yellow wire/cable (86) of the relay
B.
Connect the white wire/cable (85) of the relay to a constant 12/24v source
C.
Cut the positive wire of the motorcycle ignition coil / fuel pump / solenoid etc
D.
Connect the green wire of the relay (30) to one end of the positive wire that you cut
E.
Connect the green wire of the relay (87a) to one end of the positive wire that you cut
Pin No.
Wire Color
13
Red
14
Black
Orange
11
Blue
5
6
Grey
10
Yellow
Brown
8
Orange
7
Grey
4
9
Blue
12
Green
1
Red
2
Green
3
Black
All rights reserved. ©2011 DIY TRACK
Function/Specification Description
Power positive pole, 8-60V DC
Negative / Ground
Future Use
Future Use
Engine Immobilizer
Ignition status Detection
Future Use
Panic Button
Future Use
Mic+
Mic-
3.3V Power
RF Data
Ground
5
10amp fuse
GND
M
M c i
c i
A
Relay
86
30
87a
85
D
C
B
+12/24v
E
GND
+12/24v
Ignition Coil
Fuel Pump
Solenoid