EDgun EDMS Manual - Página 15

Navegue en línea o descargue pdf Manual para Instrumentos de medida EDgun EDMS. EDgun EDMS 16 páginas. Digital measuring system

If the pressure drop rate of pressure is higher than 1 bar in 0.25 seconds, then the

pressure gauge switches to the pressure drop measurement mode after the shot and

fixes this value.

If this value is close to the average pressure drop per shot (AVG), which is already

in the memory of the EDMS (after the previous series of shots), it will add to the

statistics, and the best reading will not be available.

The easiest way to avoid this phenomenon is after a filling not to close the valve for

a few seconds and allow the air in the tank to cool a little while being connected to

the air in the air source (5-15 seconds, depends on the pressure drop and the volume

of the vessel). Filling a PCP air tank slowly is an excellent practice to follow on all

regulated guns.

It is essential to make the first shot correctly for the EDMS to record your gun's

efficiency accurately. Before you start, it's better to reset the statistics. Statistics

must reset when changing the rifle's settings, change the caliber, change the speed,

or switch to other bullets.

Please pay attention

how to replace the battery.

1. To replace the battery, you will need an empty syringe with a volume of at least

5 cm3.

2. Removing the sticker from the side of the gauge is necessary.

3. Insert the nozzle of the syringe (not the needle) into the hole on the side surface

of the pressure gauge, so that it fits tightly into the hole, push the plunger and catch

the cap. When creating excess pressure under the cap, it flies out of its place.

4. Replace the battery and assemble the pressure gauge in the reverse order.

5. The gauge cover is cap inserted into its place, the window in the cap is aligned

on the screen and snaps on the edges.

•

If you need to rotate the screen (board with a display), for example, to align it

for your specific rifle, it is better to take it out (like when changing the battery), turn

it to the desired angle and insert it. Pay attention that under the battery there was no

twisted wire (double thickness).