DIZHUO DB125A/W Manual de funcionamiento, instalación y mantenimiento - Página 8

Navegue en línea o descargue pdf Manual de funcionamiento, instalación y mantenimiento para Fabricador de hielo DIZHUO DB125A/W. DIZHUO DB125A/W 15 páginas.

Imprimir página
5

1.5Unpacking

①Before unpacking, check whether the outer packing
machine is well and the machine model is consistent
with you purchased.
②Remove the shipping tape on the door and evaporator
(ice tray)
③Remove the protective film on the shell.
Remove the attachment and check the
type and quantity
Plastic adjustment foot 4 pieces（DB75A/W, DB95A/W,
DB125A/W plus 4 counter installation foot）
Plastic ice scraper
Inlet pipe
Drain pipe
Drain pipe clamp
Specification
Warranty card

1.6 Choose installation location

The ice maker is not suitable for outdoor use , don't
get close to the location of the source of heat or direct
sunlight.
Working environment temperature should be5 ℃ ~ 38
℃,the normal work of the water temperature should be
5 ℃ ~ 35 ℃ . If the ice machine long time work beyond
the normal working temperature range , may affect ice
-making capacity.
Ice machine should be installed in a solid, flat ground.
Don't put any items in front of the ice machine ventilation
window.
Ice machine can not work in sub-zero temperatures. To
prevent water supply line fault , when air temperature
is below freezing , please drain the water in the ice
machine (see "preparations for long-term storage of
ice machine").

1.7The ice maker level adjustment

Adjust the four foot adjustable part twist in the end,
andthen adjust the foot twist into ice machine bottom
corresponding installation hole.
Move the ice machine to install location.
Use spirit level to maker ice machine keep horizontality.
Using counter board foot, ice machine level adjustment
do not use the method of adjustment level in the bottom
of foot pad hard objects. To ensure the four foot of ice
machine touches the ground steady, to prevent vibration
when machine is running.
1
1
1
1
1
1
Notice
DB Series Internet Of Things ice Machine

1.8 Power supply

Wiring used in power supply must be reliable grounding, The
wiring use must accord with the local countries and regions
laws and regulations.
Ice machine starting, allows the voltage fluctuation
range is + / - 10% of rated voltage.
The ice maker must have a separate fuse/circuit
breakers.
The maximum capacity of this series machine we
recommended fuse is 15 A.

1.9Water supply/drainage

The water supply
According to the local water supply condition, to
determinewhether to need to install the watertreatment
system, used to prevent formation sediment, and filter
out the impurities, removethe smell of bleach.
Ice machine must be connected to a drinkable water.
Don't put ice machine connected with hot water .
If the water pressure over the allowed maximum
feed waterpressure of (5 bar), pls buy a water
pressure regulator.
Ice machine must be installed water valve in front
of all theinlet pipe.
Drainage
When installing a drain, should prevent water poured into
the ice machine or the ice storage bin , please observe the
following guidelines:
Main drain should be thick enough, to be able to
dischargeall the water in the drain pipe.
Ice storage bin and water-cooling condenser pipes
should be separated, and coated heat preservation
material, in order to prevent condensation.
Every one metre long drainage pipe must have a drop
of 2.5 cm. And there can not be bended.
Please follow the following guide to install water supply
pipe:
Good
Downward sloping
warning
warning
Effect is bad
Upward sloping
Effect is bad