EDI ED400D-E-111-4D-N4-SR1 Manual del producto - Página 3

Navegue en línea o descargue pdf Manual del producto para Instrumentos de medida EDI ED400D-E-111-4D-N4-SR1. EDI ED400D-E-111-4D-N4-SR1 5 páginas.

Imprimir página

"FUNCTION" DIP switches four and five are used to specify the baud rate of the

serial input. The options are shown in Table 1 below.

"FUNCTION" DIP switches seven and eight are not used an should be left in the

'OFF' position.

"FUNCTION" DIP switch number six determines whether this display is to be

used for 'normal' serial messages or as the output display for Electronic Displays

Analog-to-Digital converter. If "FUNCTION" DIP switch number six is in the OFF

position, the "ADDRESS" DIP switch specifies the display address as shown in

Tables 2 and 3 below. If "FUNCTION" DIP switch number six is in the ON

position, the "ADDRESS" DIP switch specifies what digits to display as shown in

the section entitled ""ADDRESS" Switch for Analog-to-Digital converter

Displays:" below.

"ADDRESS" Switch for Serial Input Displays:

"FUNCTION" DIP switch number six must be in the 'OFF' position (see above).

The "ADDRESS" DIP switches are used in binary fashion to generate an address

number. If the address number is zero (all switches in the 'OFF' position) or if

the address number is larger than 198, the display uses non-addressable 'flex'

protocol. If the address number is from 1 to 99 (see samples in Table 2 below),

the display uses 2-digit addressable 'flex' protocol. If the address number is from

100 to 198 (see samples in Table 3 on the next page), the display uses 2-digit

addressable protocol.

'ADDRESS' DIP SWITCHES

SW8

SW7

SW6

OFF

PRODUCT MANUAL

'FUNCTION' DIP SWITCH

SW5

OFF

Table 1

SW5

SW4

OFF

BAUD RATE

SW4

OFF

1200

2400

OFF

4800

9600

SW3

SW2

OFF

ADDRESS

SW1

OFF