ArtFox Pixel Blinder Bar Manual del usuario - Página 13

Navegue en línea o descargue pdf Manual del usuario para Equipo para DJ ArtFox Pixel Blinder Bar. ArtFox Pixel Blinder Bar 14 páginas.

Imprimir página

7. Trouble shooting

Following are a few common problems that may occur during operation. Here are some
suggestions for easy troubleshooting:
A. The fixture does not work, no light
1.
Check the connection of power and main fuse.
2.
Measure the mains voltage on the main connector.
Not responding to DMX controller
1.
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
2.
If the DMX LED is on and no response to the channel, check the address settings and
DMX polarity.
3.
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of
the fixture or the previous one.
4.
Try to use another DMX controller.
5.
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
Some fixtures don't respond to the easy controller
1.
You may have a break in the DMX cabling.
2.
Check the LED for the response of the master/ slave mode signal.
No response to the sound
1.
Make sure the fixture does not receive DMX signal.
2.
Check microphone to see if it is good by tapping the microphone.
One of the channels is not working well
1.
The stepper motor might be damaged or the cable connected to the PCB is broken.
2.
The motor's drive IC on the PCB migh to ubte of condition.
9C