EDIC-mini EM Card16 Series Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Grabadora de voz EDIC-mini EM Card16 Series. EDIC-mini EM Card16 Series 7 páginas. Digital voice recorders
Imprimir página
Operating the Recorder
7. Battery Charging
Before using the Recorder, check battery charge level. If there is a necessity, charge the internal battery
of the Recorder by following the procedure: remove memory card from the Recorder, and insert it into
memory card slot, charging cable included. Then connect the cable to the PC or any power supply unit
that has a 5 volt USB connector with a current of at least 500 mA, no more than 1000 mA. The red LED
will be on to indicate battery charging, which takes 3-4 hours. After that the green LED will be on to
indicate charging has been completed. Disconnect the cable off the PC or charger, then gently press the
inner part of the slot with cable connector and remove the cable from the Recorder.
Attention!!! Pulling the cable out of the Recorder may damage memory card slot, which is not covered
by warranty.
Important!!! In order to prevent battery failure, do not store the device in a discharged state. Charge it
at least once a month.
7.1 For voice recorders with external power source
Connect a DC voltage source (3.6-6V) to connectors 1 (gold wire - minus) and 2 (red wire - plus) of the
cable from the delivery set. If the voltage source is a Li-Pol battery, then by connecting the contacts 2
and 3 (green wire) of the cable you can provide current of 100 mA (by connecting an adapter to the
voice recorder and connecting the adapter to the computer's USB)
8. Recording
Shift the Switch from OFF to ON position in order to switch the Recorder to operating mode. After that,
the Recorder will switch to Record Mode, which is confirmed by 5 flashes of red LED. In case of the
absence or malfunction of the microSD card, there will be 10 flashes repeated every 5 seconds, until
microSD card is inserted or the Recorder is disabled.
During recording, the LED flashes in 2 series, the number of flashes shows:
Number of flashes
1
2
3
4
The interval between the first and second series of flashes is 4 seconds, and then, after 8s, the first
series follows, etc. If recording cannot be started, there is a red LED flashing:
3 red flashes indicate low battery
Battery charge level
(1st series)
70-100%
30-60%
0-30%
Free memory capacity
(2nd series)
75-100%
50-75%
25-50%
1-25%
4