FiTech 40005 Instrucciones de instalación
Navegue en línea o descargue pdf Instrucciones de instalación para Bomba de agua FiTech 40005. FiTech 40005 4 páginas. Inline frame mount fuel pump kit
Imprimir página
FiTech
Fuel Injection
The FiTech Inline Fuel Pump Fuel Delivery Kit is an in-
expensive solution for a fuel delivery system. This style
of fuel delivery when used with a FiTech Go System EFI
does require a return line to the fuel
tank. All necessary hose, hose ends,
and fittings are supplied.
The most critical aspect of this
installation is making sure that the
fuel pump and the filter between the
pump and the tank are mounted as
low as possible. Ideally the pump
should be at least as low as the bot-
tom of the tank. These pumps are
engineered to push fuel, not draw it
in from the tank. Even though the
pickup from the tank may be higher
Plumbing Layout for External Frame Mount
Inline Pump Fuel Delivery Kit
#40005
Return fuel Line to tank (-06 AN Hose)
Note that the FiTech EFI Throttle Body has
three fuel inlet ports that can be used. Two
additional ports are marked "A" below. Any
unused port should have a plug installed.
"A"
"A"
Go EFI or Go+EFI
Throttle Body
Inline Frame Mount Fuel Pump Kit
T
The Inline Fuel Pump Kit can be used in conjunction with any EFI system. These
instructions are focused on pairing it with a FiTech EFI System but the instructions
can easily be adapted to suit any other EFI system that is being utilized.
40005 Kit Contents
5' of -08 EFI Fuel Hose - Push Lock
20' of -06 EFI Fuel Hose - Push Lock
(1) 100 Micron Inline Fuel Filter
(1) 30 Micron Inline Fuel Filter
(1) 255 L/PH Inline EFI Fuel Pump
(1) Billet Pump Mounting Bracket
(1) -08 x M22 Fitting for Fuel Pump
(1) -06 x 9/16-24 Fitting for Fuel Pump
(3) -06 AN Straight Hose Ends (Push Lock)
(3) -08 AN Straight Hose Ends (Push Lock)
(2) -06 AN 45° Hose End (Push Lock)
(4) #10 Self Tapping Metal Screws
These two components
must be mounted as low
as the lowest point of the
Fuel Tank. Both should be
within 3-ft of the tank.
IN
-06 AN Hose
Post-Filter
Fuel Pump Billet Bracket
Installation Instructions
than the pump, once this line is primed it will function
satisfactorily. Note that mounting the pump too high will
contribute to premature failure. Please read the complete
-08 AN Hose
-06 AN Hose
(#40005)
instruction manual so you have a
good oversight of the installation.
The Inline Fuel Pump Fuel De-
livery Kit is capable of providing
enough fuel for engines producing
up to 600 HP when used with ei-
ther the 4-injector FiTech EFI sys-
tems or also when used with the
8-injector units. Note that these
systems are still suitable to be
used on engines that are making
as little as 200 HP.
Fuel Tank
Pre-Fuel Filter
-08 AN Hose
Adel Clamp
Fuel Pump
Figure 1