dji AGRAS MG-1S RTK Manual de inicio rápido - Página 15
Navegue en línea o descargue pdf Manual de inicio rápido para Drones dji AGRAS MG-1S RTK. dji AGRAS MG-1S RTK 20 páginas.
Imprimir página
Using Intelligent Operation Planning System
The remote controller equips a highlighted screen with a built-in Android system, which can run the DJI MG
app. Measure operation area and obstacles, configure waypoints, and other settings via the intelligent operation
planning system built-in the app, and the app will produce a flight route according to the settings. The aircraft can
operate automatically following the flight route when it is in F-mode.
Planning Flight Routes
Ensure that the aircraft is powered off when planning your flight route.
DJI MG
APP
Turn on the remote
controller
Go to DJI MG app
Walk alongside the
boundary
Tap "Add Waypoint C2"
at turning points
Tap "End
Measurement"
The calibration point is used to rectify the bias of the flight route caused by the positioning difference between
the remote controller and aircraft. Choose a fixed reference point for calibration like a metal peg or obvious
marker that is easy to identify for bias rectification when executing the same task.
Starting Task
Put the aircraft to the
calibration point
Tap "Rectify Offset"
Be sure to take off in open areas.
The task will be cancelled automatically if motors are started before starting the task. You need to re-call
the task in the task list.
The aircraft will hover at the ending point of the flight route after the task is completed.
Tap "Field Plan"
Tap "Start Obstacle
Measurement C1" near
the obstacle*
Adjusting the flight
route: route angle,
line spacing, and
shrink distance
Power it on
Tap "Start Task"
AGRAS MG-1S
RC
10
Satellite count ≥ 10
Positioning accuracy:
~ 2m
Walk alongside the
obstacle and tap "Add
Waypoint C2" to add
several waypoints*
Walk to the location of
the calibration point. Tap
"Add Calibration Point
C3"
*If any obstacle exists in the operating area.
·
Toggle the Flight Mode
Switch to F-mode
"Slide to Execute"
©
2017 DJI All Rights Reserved.
Quick Start Guide
Tap "Start Measuring"
Tap "End Obstacle
Measurement C1"*
Save the task
Select from the "Task
List" and "Use Task"
15