Altronics Biema A 4154 Series Instrucciones de uso - Página 2
Navegue en línea o descargue pdf Instrucciones de uso para Amplificador Altronics Biema A 4154 Series. Altronics Biema A 4154 Series 3 páginas.
Stereo Power Amplifiers
Front panel:
1. Power ON/OFF. When switched ON, Soft start
will protect the speaker load from spikes.
2. Power LED (Blue). LED will light when 240VAC is
connected and POWER switch is ON.
3. Protect LED (Orange). This LED will light under
any one of the following three conditions:
a. At power ON, whilst soft start is active. Soft start
will take approx 3-5 seconds.
b. If the output stage reaches 85deg C due to
overload condition.
c. Power supply failure.
4. and 6. Channel A and channel B clip LED's (Red).
These LED's will light under two different
conditions:
a. When maximum output is achieved
b. If a short circuit condition exists across the
amplifier outputs.
5. Channel A level control.
7. Channel B level control.
B
INPUTS
B C D
REAR PANEL LEGEND
1. Channel B input 6.35mm jack
2. Stereo RCA inputs for channel A and B
3. Channel A input 6.35mm jack
4. Lift / Ground switch
5. Channel B output 6.35mm
6. Channel B output binding post
Page 2
ON
Prot
Clip
C
D
E F
L
K
OUTPUTS
Ground
Lift
E F
G
H
Rear Panel:
1. Channel B input. 6.35mm mono jack.
2. Stereo RCA inputs for Channels A and B
3. Channel A input. 6.35mm mono jack.
4. Lift / Ground Switch. This switch is used to help
isolate ground loops or hum.
5. 6. and 10. Channel B output. Heavy duty speaker
connector, binding posts, and 6.35mm Jack.
7. 8. and 11. Channel A output. Heavy duty speaker
connector, binding posts, and 6.35mm Jack.
9. Mains power input. IEC socket with fuseholder.
Clip
G
H
I
7. Channel A output binding post
8. Channel A output 6.35mm
9. 240V Mains Input
10. Channel B output H/D speaker connector
11. Channel A output H/D speaker connector
FRONT PANEL LEGEND
1. Power Switch
2. Power LED
3. Protection LED
4. Channel A clip LED
5. Channel A level control
6. Channel B clip LED
7. Channel B level control
240V AC Mains
J