Before Flying
1.
Installing the Transmitter Batteries
1. Open the battery compartment cover of the Transmitter.
2. Install 4x AA battery (5#) in accordance with the + /- pole.
3. Close the battery compartment cover of the Transmitter.
1. DO NOT use the PHANTOM transmitter (receiver) with the third party remote control equipment.
2. Risk of explosion if replaced by an incorrect type.
3. Dispose of used batteries according to the instructions.
4. Remove the batteries after use.
2.
Battery Charging – LiPo Battery
Please use the full charged battery of 3SLiPo.(Recommendedparameters:2200MAH-20C－11.1V.)
The built-in ESCs of PHANTOM ONLY support 3S (11.1V) power supply. DO NOT use the battery of higher
voltage.
3.
Fitting the Propeller
1. First prepare the aircraft and the propellers (original 8-inch).
2. Assemble the propellers (the side with rotary mark facing up) to the aircraft. Make sure the rotary mark on
the propeller is the same as the mark on the frame arm. The arrow's direction stands for the rotating
direction of the motors.
3. Finally fit the propeller nuts.
©2012
DJI Innovations. All Rights Reserved.
4.
Mount the Landing Gear with the Compass Module if Required
If the GPS ATTI. Mode is desired, you must first mount the landing gear which contains the Compass Module.
1.
Prepare the aircraft and the landing gear.
2.
Mount the landing gear with the Compass Module to the right part (shown as the following chart); make sure
the 5-pin cable is through the hole of the landing gear. Fix the landing gear with screws (M3x6), and then
connect the 5-pin cable to the Compass Module.
3.
Mount the other landing gear to the left part.
4.
Fix the antenna and the 5-pin cable on both landing gear by using the white adhesive tape
Landing Gear Mounting
When flying, please make sure the compass module is stationary and firm.
If the Landing Gear with the compass module mount on has been deformed, please replace it with a new
one and mount it as the procedures above.
The compass module is not waterproof, and not anti-oil.
5.
Turn on the Transmitter
1. Lower the throttle stick to bottom position, and set the IOC and Control Mode switch to the top position.
2. Turn on the power switch of the Transmitter，when the linking is successful, the LED indicator on the
Transmitter will change to solid red.
Makesuretokeepthethrottle stick at the bottom position before the LED change to solid red!!!
9 |
©2012
DJI Innovations. All Rights Reserved.
Compass Module Connecting
10 |
Imprimir página