ARTHUR HOLM DTalk Manual de montaje - Página 2

Navegue en línea o descargue pdf Manual de montaje para Monitor ARTHUR HOLM DTalk. ARTHUR HOLM DTalk 9 páginas.

INTRODUCTION

Dynamic 3 monitor is available in a special version prepared to be

assembled with DynamicTalk device. This special version is supplied

with all accessories to be assembled.

DynamicTalk can be assembled at the right side, at left side or at both

sides. This guide shows how to assemble it at left side (the assembling

at the right side follows the same process).

PATTERN HOLE

Pattern hole dimensions for milling are specified in the general dimensions for each reference.

ATTENTION

Manipulation of the product should be avoided, no stress should be applied to the product except from

the instructions given in this document. Cutting, drilling, soldering, adding of electrical and mechanical

components can cause danger and should be avoided by all mean. Not complying with these direction

will result in a lost of the Arthur Holm warranty. Albiral Display Solution S.L. shall not be held liable for

any loss or injury incurred as a result of modifications made to goods by anyone other than the supplier

or the supplier's authorised representative without the supplier's written permission. Such

modifications shall be deemed to terminate any further guarantee obligations. Compensation will not be

paid for wages, loss of profit, waste of time, packing and transport or any financial liability resulting

from defects in the goods. (Albiral Display Solutions shall not be liable for any loss or injury caused by

negligence.)

Information