Acova 874110 Manual de instrucciones - Página 17

Navegue en línea o descargue pdf Manual de instrucciones para Calentador Acova 874110. Acova 874110 20 páginas.

Imprimir página

When the preferred ambient temperature is reached, turn the knob

clockwise until the red light

goes off.

❹

After a few hours of operation, you can change the temperature setting by tur-

ning the knob clockwise to increase temperature or anti-clockwise to reduce it. This

enables you to set your desired temperature.

4.3 Adjustment procedure

In order to make setting easier, the knob for temperature setting is graduated

by degrees and equipped with an adjustment dial

and

turn simultaneously.

❻)

The dial is initially set to correspond to the actual ambient temperature in the

room (under optimum thermal conditions).

However, due to the specific conditions of an installation or room (location,

power/volume, insulation, etc.), a variation may be noted between the desired tempe-

rature and the measured temperature

The adjustment ring

enables this problem to be resolved.

❺

PHASE 1: SETTING THE REQUIRED TEMPERATURE

Example: The first time you use the radiator, you have set the thermostat to

20°C but the temperature measured by your thermometer in the room after heating is

only 18°C.

Turn the knob for temperature setting

ning indicator

lights up) and let the radiator heat up until your thermometer shows

❹

20°C. The functioning indicator going off denotes that your device has reached the

desired temperature.

anti-

❻

. In normal use, both elements (

❺

18°

clockwise a few degrees (the functio-

❻

20°

PHASE 2: ADJUSTMENT

Hold the knob for temperature setting

independently until the 20°C setting is in line with the marker

❺

The setting of your radiator now corresponds to the temperature measured in

the room.

PHASE 3 (OPTION): RESET TO INITIAL SETTINGS

To return to the original setting: line up the embossed point found on the knob

for temperature setting

4.4 Booster function

This function provides additional heat when you have a bath or shower, while

also drying or warming your towels.

When this function is activated, the radiator operates at maximum output

regardless of the thermostat setting.

Once initiated the booster function runs for 2 hours. It can be stopped at any

time.

There are 2 ways of starting the Booster function:

• Manual booster: TIMER

• Programmed booster: TIMERPROG

40005972

in place and turn the adjustment dial

❻

with the freeze protection symbol on the adjustment ring

❻

Freeze

protection

❼

20°

❼