FITNESS AUDIO DR-204 Manual de instrucciones - Página 2

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de micrófono FITNESS AUDIO DR-204. FITNESS AUDIO DR-204 6 páginas. Fitness audio wireless mic system

Imprimir página

{It

1i~~audIO~

INTRODUCTION

Congratulations on your purchase of the state-of-the-art Fitness Audio PLL.Synthe-

sized 16 channel frequency agile UHFhigh band or VHFprofessional wireless system.

Please read this operating manual thoroughly in order to familiarize yourself with the

controls before using.

FRONTAND

REAR

PANEL CONTROLS

1. Power Switch

2. Power On Indicator

3. RF Signal Indicator

4. Diversity Indicator

5. AF Signal Indicator

6. RFTest Button

7. Channel Selector (U-Series only)

8. Volume Control

9. Antenna B Socket

10. Fixed Mic level 20mV

11. Adjustable Line level 600mV

12. Squelch (SO) Control

13. DC INJack

14. Antenna A Socket

RFTEST

Tofindthe best channel for transmission (U-Seriesonly), ensure the receiver is con-

nected to a mixer and amplifier and press the RFTest button (6).Ifinterference is

heard select the next channel in order using switch (7) and repeat the test until a

clean channel is found. Then select the matching channel number on the Belt-Pack

Transmitter and test for voice level.

BELT-PACK T RANSMITTER

Channel Selection

and Gain

The channel selector and gain adjustment are located under the battery cover a~

shown in the picture below. To make channel selection (U-Seriesonly) remove t~

cover and select a channel by turning the Channel Selector(6)with a small screwc

Gain adjustment for Lavalierand Headset microphones can be done by adjusting I

MTtrimpot(S),whereas GTtrimpot(4)is for the gain adjustment of an ElectricGuital

or other high impedance line level inputs. Ifyou're using the Transmitter with an

Aeromic then turn down the MTtrimpot to minimum. If using an E.Micor V.Mic.

leave the MTtrimpot at full and turn down only if distortion is evident.

Due to minor variations in the casing sizes of many brands of 9Vbatteries, the

transmitter battery compartment is designed to accommodate the preferred 9V

battery made by Eveready - the Energiser 9VAlkaline

but other brands may als

work well. Re-chargeable

Ni MH batteries

@ 170-190mAH

ratings

may need to bl

recharged after about 1.5

2.0 hours of continuous use, whereas Alkaline9VBat

will generally be suitable for about 6 - 8 hours of airtime with the Aeromic or E.r

V.Micwireless microphones.

1. Battery Status Indicator

2. Power Switch

3. Microphone

Connector

4. GTTrimpot

5. MTTrimpot

6. Channel Selector (U-Seriesonl