dji RS 3 Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Accesorios para cámaras dji RS 3. dji RS 3 18 páginas.

a. Unlock the tilt axis, and loosen the mounting plate knob.

b. Rotate the tilt axis so that the camera lens is pointing upward. Check to make sure

the camera is not top or bottom-heavy. If top-heavy, move the camera backward. If

bottom-heavy, move the camera forward.

c. Tighten the knob. The vertical tilt is balanced until the camera is steady while pointing

upward.

Balancing depth for the tilt axis

a. Rotate the tilt axis so that the camera lens is pointing forward. Toggle the lever to

the unlocked position.

b. Check to make sure the camera is not front or back-heavy. If front-heavy, move the

camera backward by turning the knob. If back-heavy, move the camera forward.

c. Toggle the lever to the locked positon. The Tilt axis is balanced if the camera is steady

while tilting up or down for 45 degrees.

d. Lock the tilt axis.

Balancing the roll axis

a. Unlock the roll axis. Toggle the lever on the roll arm to the unlocked positon.

b. Check the direction in which the roll motor swings. If the camera rotates to the left,

move the camera to the right. If the camera rotates to the right, move the camera to

the left.

c. Toggle the lever on the roll arm to the locked positon. The roll axis is balanced if the

camera is steady.

d. Lock the roll axis.

Balancing the pan axis

a. Unlock the pan axis. Toggle the lever on the pan arm to the unlocked positon.

b. Hold the grip, tilt the camera forward, and adjust the pan arm to parallel to you.

Check the movement of the pan axis. If the camera lens rotates to the left, push the

pan axis to the right. If the camera lens rotates to the right, push the pan axis to the

left.

c. Toggle the lever on the pan arm to the locked positon. The pan axis is balanced if

the camera is steady when rotating the pan while lifting the grip.

Operation

Touch Screen

After installation, activation, and balancing, RS 3 must be auto-tuned before it can be used.

Home: tap gimbal calibration to start auto tune, and check the balance status, select follow

mode and follow speed by tapping the icons.

Slide to the right to select shooting modes, slide to the left to set system settings, and slide

up to enter joystick and front wheel settings page, slide down to view the image transmission.