dji Zenmuse H3-2D Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Accesorios para cámaras dji Zenmuse H3-2D. dji Zenmuse H3-2D 16 páginas.

connection

(2) GCU Power Cable

connection

(3) Gimbal TILT Control channel

Connection has been finished. They can come into use after power on.

The tilt direction of gimbal can be controlled by one channel of Autopilot System (WKM is X3, NAZA-M and

NAZA-M V2 is X1). You are asked to set the corresponding channel on your Transmitter, and connect the

corresponding port of Receiver to the Main Controller. Use the Gimbal Assistant Software to help you with

configuration.

Notes:

(1)

For H3-2D to work; it MUST be used in conjunction with Naza or WKM; do not power up the gimbal

without Naza or WKM connected.

(2)

Make sure to power on the gimbal after camera mounting, since the wrong center of gravity will cause

motor overheating and then lead to damage.

(3)

Re-do the Transmitter calibration after NAZA-M Firmware upgrade and double check other items.

(4)

Make sure connections are correct; otherwise may lead to the gimbal work abnormally or damage，even

cause the autopilot system working abnormally.

GCU and DJI Autopilot System Connection

CAN-Bus port on the WKM system.

Connect the

GCU Power Cable

solder the power cable to the power pad on aircraft.

port on the PMU V2 module.

to a connecter, if DJI Multi-rotor is used,