djm direct DJMMIG130 Manual - Página 8

Navegue en línea o descargue pdf Manual para Sistema de soldadura djm direct DJMMIG130. djm direct DJMMIG130 15 páginas.

- Inserting the welding wire and adjusting the wire guide

- Pull the pressure roller spring and swing it upward.

- Pull the pressure roller holder(E) downwards .

- Swing the screws (F) 90 °and pull off upwards.

- Check the feed roller (G). The appropriate wire thickness must be

specified on the top of the feed roller (G). The feed roller (G) is fitted

with two guide grooves. Turn the feed roller (G) over if necessary or

replace it.

- Position the feed roller holder (G) again and secure it.

- Remove the gas nozzle (10) from the torch (11) by turning it

clockwise, unscrew the contact tube (15). Place the hose package (9)

on the floor as straight as possible pointing away from the welding

set.

- Cut off the first 10 cm of the welding wire to produce a straight cut

with no shoulders, warping or dirt. Deburr the end of the welding

wire.

- Push the welding wire through the guide tube (C) between the

pressure and feed rollers (G) into the hose package mounting (H).

Carefully push the welding wire by hand into the hose package until it

projects out of the hose package by approx. 1 cm at the torch.

- Push the pressure roller holder(E) upwards and Pull the pressure

roller spring(D) and swing it downward.

- Screw the appropriate contact tube for the welding wire diameter

on to the torch and fit the gas nozzle, turning it clockwise.

- Set the adjusting screw for the roller brake (I) so that the wire can

still be moved and the roller stops automatically after the wire

guide has been braked.

10.Operation

Before any work on the machine itself, remove the mains plug from

outlet.

Setting

Since the welding set must be set to suit the specific application, we

recommend that the settings be made on the basis of a test weld.

10.1 MIG Welding principles

MIG (Metal Inert Gas) welding allows you to fuse together two

similar metals without altering the properties of the metal.

A consumable wire electrode is continuously fed through the welding

torch that is fitted with a concentric gas nozzle. the wire is connected

to a high voltage supply which creates an electric arc between the

electrode (the wire) and the workpiece. The arc is used to create the

required heat to turn the metal into a molten state. The wire is used

as both the electrode and as a filler.

The gas is used to prevent oxidation and to shield the arc and the

weld from atmospheric contamination. The choice of gas is

dependent upon the material being welded.