djpower FLAME MACHINE HF-210 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Equipo para DJ djpower FLAME MACHINE HF-210. djpower FLAME MACHINE HF-210 16 páginas.

Imprimir página

Note:

1. Safety distances for Wave flame machine are indicated in above picture. At least 15m in all projection directions, at least 5m to the other

sides of the device. In order to indicate correct direction, please place the top panel correctly.

2. Open the top cover of the flamer from the "OPEN" position, take out the flame fluid can, and add the fuel.

3. The nozzle is still hot after the flamer worked, to prevent burns, do not touch, wait for natural cooling.

5.4.2.

Quick Operation Sheet

Immediately upon receiving the machine, carefully unpack the carton, check the machine received in good condition. Ensure safety operation

of machine, please do following below operation procedures when operate flame machine.

Schematic

Operation

diagram

step

Installation

Locate safety

lock at TEST

MODE

Fueling

Power and DMX

cable

connection

Setting for

adjustment of

the angle

Switch ON the

machine

Set DMX

address

Pressurize

Check device

status in TEST

MODE

Explanation

The device can only be placed horizontally, if placed on truss, please locked with extra safety cables.

Before operate machine please locate safety lock at TEST MODE.

Under TEST MODE, operator can test the rotation of nozzle, but the fuel ejection function is disabled

to prevent firing.

Under USER MODE: the device can run normally. Please strictly follow the safety distance requirement.

Human beings, animal or flammable objects shall be away from the danger area.

Take out the flame fluid can and add fuel; carefully put it back into the cabinet to avoid spilling; ensure

that the tube is placed in the fluid can; tighten the container cap. Please use the designated suitable

fuels.

Two power supplies are available for selection: 1). 110V/220V main power supply; 2). 12V battery

power supply.

Setting for adjustment of the angle

Disconnect the DMX signal and adjust the angle selection. It can be adjusted to full angle mode and

other fixed angle modes. When adjusting to the full-angle mode, you need to place the limit bar on

the protective fence to the maximum angle position, or remove the protective fence. Otherwise, the

rotating motor will be damaged and the machine will not rotate normally.

Please confirm safety lock located at TEST MODE before switch on the unit.

The unit has 6 channels. Detailed information please refer to DMX channels.

Under DMX control: Channel 6= 50~200.

Reconfirm safety lock located at TEST MODE before test. In this status, the nozzle will rotate, and

igniter will be activated, but there is no flame effect because no fuel output. In case DMX control is

used to test the sequence, It is suggested to set CH1 at 128, so that nozzle stays at straight up

position after firing.

- 8 -