Custom Dynamics Dynamic Strips CD-DS-ST-CC Manual de instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Accesorios para motocicletas Custom Dynamics Dynamic Strips CD-DS-ST-CC. Custom Dynamics Dynamic Strips CD-DS-ST-CC 7 páginas.

Imprimir página

Remove the tie-wraps that secure the Dynamic Strips™

together and un-wrap the wires. Take the right strip and

place it over the 2 bolts that secure the cover. Using a

suitable pen or pencil, tilt the strip outward, noting the wire

outlet, then mark its location on the edge. Remove the strip,

then carry the mark to the center of the cover, equal points

between the 2 screws. Repeat for the other side.

Remove

Front Plate

Side Rail

Remove

Take steps to protect the headlamp before working in this area. We have covered ours with a soft microfiber cloth.

There are 5 components that make up the cover: the front plate, side rails left/right and rear plates left/right. Remove the 3

screws (per side) that secure the fork cover assemblies. Note the screw locations in the photos A & B. The front plate in photo A

will remain fixed on the bike, while the rear plates L/R highlighted in photo B will be removed. Note that only the top screw in the

rear plate needs to be removed. Take care with these parts as they are painted and can chip or scratch easily. Stage removed

pieces so they can be drilled.

Using a 1/4" drill bit, drill the side rails using the punch mark made in step 8. Repeat for the other side.

Next, mount side rails back in place and use as a reference to mark and punch the left and right rear covers. Use a

center punch to mark the location before drilling. Remove both side rails and rear covers, then drill each rear cover.

Remount the left and right rear covers back in place and use as a reference to mark and punch each side of the

front cover. Use a center punch to mark the location before drilling. Do not drill the front cover yet, there are special

instructions on the next page.

Questions? Call us at: 1 (800) 382-1388

Installation Instructions - Page 3

M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

Use a center punch at the marked location to ensure a

guide for the drill bit. Repeat for the other side.

Remove

Rear plate

09-2017