Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV Instrucciones de instalación - Página 5
Navegue en línea o descargue pdf Instrucciones de instalación para Accesorios para automóviles Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV. Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV 5 páginas. Run brake turn controller with built in strobe/flasher
Imprimir páginaSMART TRIPLE PLAY® Run Brake Turn Controller with
Built in Strobe/Flasher (Patent Pending)
7. The Smart Triple Play ® allows you to program the running light brightness of the turn signals so
they are a match to your center taillight.
Turn ignition key off, be sure Switch 1 and Switch 2 are in the OFF position and the Rotary Dial
•
in in the 0 position.
Turn ignition key on, immediately turn Switch 1 On Off On. Turn Switch 2 On OFF On. Turn the
•
Rotary dial one complete clockwise revolution back past position 0 and stop. Do not depress
Brake or Turns Signals during this action.
The turn signals should now fade up and down slowly, do not proceed unless this confirmation
•
takes place.
Turn the rotary dial clockwise, increasing numbers, to increase the brightness of the running
•
lights. Match the running light brightness to the taillight. Once happy with the setting, press and
hold the brake for a couple of seconds. The setting will now be saved.
8. Turn ignition key Off and set switches for desired Operation.
Switch 1 On, Switch 2 On: Strobes/Flashes on all three Rear Lights
Switch 1 On, Switch 2 Off: Strobes/Flashes on rear turn signals only
Switch 1 Off, Switch 2 On: Strobes/Flashes on center light only
Switch 1 Off, Switch 2 Off: No Strobes/Flashes
Rotary Switch Setting to set Brake Flash/Strobe Pattern:
Pattern 0: Four Flashes then Solid (Incandescent or LED)
Pattern 1: Four Flashes, Solid for 3 Seconds, Repeat (Incandescent or LED)
Pattern 2: Seven Flashes then Solid (Incandescent or LED)
Pattern 3: Seven Flashers, Solid for 3 Seconds, Repeat (Incandescent or LED)
Pattern 4: Quad Strobe then Solid for 1 Second then Quad Strobe (LED Only)
Pattern 5: Quad Strobe, Solid for 1 Second, then Quad Strobe, Solid for 3 Seconds, Repeat (LED
Only)
Pattern 6: Blaster X Pattern for 3 seconds, then Solid (LED Only)
Pattern 7: Constant Blaster X Pattern (LED Only)
Pattern 8: Constant Fast Strobe 5 Seconds, then Solid (LED Only)
Pattern 9: Constant Fast Strobe Pattern (LED Only)
Installation Instructions
9. Turn ignition key on and Test Operation based on your desired switch
settings.
10. Reinstall Seat.