DK Digital DCR-4000 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Receptor para automóvil DK Digital DCR-4000. DK Digital DCR-4000 20 páginas. Stereo cd / mp3 car radio

Imprimir página

General Operation

Switching the radio on / off

Press the PWR button with the car ignition turned on to switch on the device. The buttons

now light up in blue and you can read Welcome in the display, which quickly disappears.

Then the radio frequency is displayed. Push the button again to switch off the

Controlling the volume

Turn the VOL knob clockwise to increase the volume. In the display you can read a value

between 0 and 47. Turn the knob anticlockwise to reduce the volume.

Tone control

Bass

When you press the PUSH SELECT button twice, BAS appears in the display for five

seconds. Now turn the VOL knob to lower or raise deep frequencies. The respective value

from -7 to + 7 is shown in the

Treble

When you press the PUSH SELECT button three times, TRE appears in the display for five

seconds. Now turn the VOL knob to lower or raise high frequencies. The respective value

from -7 to + 7 is shown in the

Balance

When you push the PUSH SELECT button four times, BAL appears in the display for five

seconds. Now turn the VOL knob to adjust the volume ratio between right and left

loudspeakers. The respective value between 10L (left side only) and 0 (centred) to 10R

(right side only) is shown in the display.

Fader

When you push the PUSH SELECT button five times, FAD appears in the display for five

seconds. Now turn the VOL knob to adjust the volume ratio between front and rear

loudspeakers. The respective value between 10R (rear loudspeakers only) and 0 (centred)

to 10F (front loudspeakers only) is shown in the

Other settings

Press the PUSH SELECT button for two seconds. When you press the PUSH SELECT button

again for a short period of time, you can now set many parameters for the operating modes

of the device:

1. TA ALARM / TA SEEK

The display now shows TA ALARM or TA SEEK for approx. 10 seconds. This means:

• TA ALARM - If you activate the TA function (page 14) only for listening to radio channels,

which broadcast traffic reports as well and you select a radio channel, which does not

broadcast traffic reports, the device will notify you of that fact by a regular "beep" sound

and by displaying "NO TP,TA".

• TA SEEK - If you activate the TA function and you select a radio channel, which does not

broadcast traffic reports, the device will automatically seek a radio channel, which

display.

device.