Artison Nano One Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Subwoofer Artison Nano One. Artison Nano One 12 páginas.

INPUT PANEL

POWER TOGGLE – Master Power ON / OFF toggle switch.

AC POWER INPUT – Mains power input. Standard IEC-C8 input accepts

standard IEC-C7 connector.

LOW PASS FILTER – This rotary setting from 60 – 160 Hz adjusts the upper end of the

subwoofer's frequency response. This setting is infinitely adjustable in the range. This

should be set according to your satellite speaker's specifications. When using a LFE

signal, turn this rotary knob all the way to the top setting past 160 Hz, this will bypass the

LPF and allow full range input signal. Only use this setting if your electronics has a LFE

output.

PHASE CONTROL – Phase control is used to time-align the output signal from the

subwoofer to the other speakers in your system. This setting is best done by ear from the

normal listening position listening to both the satellite and subwoofer speakers.

12 VOLT TRIGGER – Using the 2 pin green phoenix connector, this controls the Nano

One's ON / STANDBY setting based on a 12 Volt DC input signal. This connection is

polarity free meaning there is no specified positive and negative input.

IR CONTROL – Using a 3.5 mm Minijack input, this allows an external control system to

send IR commands directly to the subwoofer without the need for an external IR emitter.

LPF SLOPE – The two settings are 12 dB/octave and 24 dB/octave. This adjustment to

the Low Pass Filter controls the roll off or slope rate of the upper end of the subwoofer's

frequency response. The proper setting depends on your satellite speaker's specifications

and personal taste.

POWER ON SETTINGS – These three settings control how the subwoofer comes in and

out of STANDBY:

i. Audio Sense – On with active audio signal. STANDBY after ~15

minutes of inactivity.

ii. 12 Volt Trigger – On with 12 V Trigger input. See Item #5 above.

iii. On – On and Standby with the front button or IR remote

LFE / LINE LEVEL INPUT – Use this 3.5mm Minijack input for an AVR's LFE / Subwoofer

output. Utilize the Female RCA to 3.5mm Minijack adapter included with this product.

10. HIGH LEVEL INPUT – Using the 4 pin phoenix connector, connect an amplified Left and

Right speaker output to the Nano. Please note the polarity of the markings on this input's

label.

11. SERIAL NUMBER - Please save this number for future reference.