Artison RCC600-SM Manual de instalación - Página 12

Navegue en línea o descargue pdf Manual de instalación para Amplificador Artison RCC600-SM. Artison RCC600-SM 13 páginas. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
También para Artison RCC600-SM: Manual de instalación (19 páginas)

Imprimir página

1. AUTO EQ MIC – This is the input jack for the ARMC Microphone.

2. Switch Settings – Select either:

a. BYPASS – ARMC not active.

b. AUTO EQ. – ARMC active. Will remember the last measured room mode sequence

and settings.

3. BLUE LED STATUS INDICATOR

a. Continuous Short Flash – Switch in AUTO EQ setting, ARMC not yet saved. Since

the amplifier leaves the factory with this function having been tested the LED should

not flash continuously even when the switch is set to the AUTO EQ position.

is important that you do a room mode set up using the supplied microphone at

your listening position if you plan to use the amplifier in this setting

b. One Long, Two Short Flashes – Amplifier Error, Shorted Audio Outputs.

the amplifier from the wires to the RCC600 SA and use an ohm meter to check

for shorts in the line.

c. One Long, Three Short Flashes – Over Temperature Indicator.

amplifier has adequate ventilation. If the situation continues to exist contact

Artison.

4. Calibrate Button – Place the supplied microphone in the desired listening position and

plug it into the AUTO EQ MIC input jack. Press the button for a few seconds to initiate

ARMC sequence.

NOTE: It

Remove

Be sure that the