DK-TEC SP31205 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Cortacésped DK-TEC SP31205. DK-TEC SP31205 15 páginas. Atv mower

Connect the machine after the towing device

1. Check that the knife blades are not blocked by grass and other foreign objects.

2. Check all electrical connections for accumulated grass and other foreign objects

before operation.

the tires to make sure they have the right tire pressure.

Check

TIRE WARNING

Do not pump too hard (max 30psi) and do not use worn tires or tires that cannot hold air.

Serious damage can occur if a tire explodes while the machine is being operated. Do not skip

the maximum speed of 8 kilometers per hour.

4. Check the engine oil before starting the engine.

5. Determine which towing position is best for your vehicle.

Option 1: Straight move

Option 2: Side mounted

NOTE

If the machine is pulled after a lawn mower with side ejection, the machine should be

side-mounted to the side where the towing unit

thrown into the engine of the machine.

6. Adjust the cutting height (See Knife Height Adjustment).

7. Refer to the towing unit's owner's manual for correct towing .

8. Reverse the towing unit to the desired pulling position.

9. Connect the drawbar. It must be ensured that the clutch is locked before pulling the machine

off.

TOWING WARNING

Serious injury or death may occur if safety regulations are not followed. It must always be ensured

that the mower is locked to the towing device's towing device before driving it. Drive carefully. Pay

attention to the added length of the mower. Never exceed the maximum towing speed of 15

kilometers per hour. Never sit on or transport anything on the mower. Always turn off the

engine of the towing unit and the engine of the machine before leaving the machine.

Knife height adjustment

1. The engine

of the machine

2. The height

of the knife

blades and counterclockwise to raise the knife blades. See the illustration on the next page.

3. It must be ensured that the cutting deck is in wads and this is done by adjusting the draft boom.

NOTE: The drawbar can be side-shifted.

must be turned off before adjusting the blade height.

blades is adjusted by turning the handle clockwise to lower the knife

does

not eject, to prevent grass from being