DK2 EW8020 Instrucciones de montaje y uso - Página 8

Navegue en línea o descargue pdf Instrucciones de montaje y uso para Cabrestantes DK2 EW8020. DK2 EW8020 14 páginas.

n. The vehicle to be winched should be placed in neutral and the emergency brake

released. Only release the brake pedal when under full tension. Avoid shock loads to

the winch. This can damage the winch, rope and vehicle.

o. The winch is meant for intermittent use. Under full load with a single line rig do not

power in for more than a minute without letting the motor cool down for a few minutes

and then resume the winching operation.

p. The winching operation is complete once the vehicle is on stable ground and is able

to drive under its own power.

q. Secure the vehicle. Be sure to set the brakes and place the vehicle in park.

r. Release the tension on the strap. The winch is not meant to hold the vehicle for long

periods of time.

s. Disconnect the strap from the anchor.

t. Rewind the strap. Make sure that any strap already on the drum has spooled tightly

and neatly. If not, draw out the strap and re-spool from the point where the strap is

tight.

u. Keep your hands clear of the winch drum and fairlead as the strap is being drawn

in.

v. Secure the hook and hook strap.

w. Disconnect the remote control and store in a clean, dry place.

x. Clean and inspect connections and mounting hardware for next winching operation.

Periodically check the tightness of mounting bolts and electrical connections.

Remove all dirt or corrosion and always keep clean.

Do not attempt to disassemble the gear box. Repairs should be done by the

manufacturer or an authorized repair center.

The gear box has been lubricated using a high temperature lithium grease and is

sealed at the factory. No internal lubrication is required.

MAINTENANCE