Aluma Tower Company TM52-60 Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Vehículo utilitario Aluma Tower Company TM52-60. Aluma Tower Company TM52-60 12 páginas. Tower setup with guy wires includes guying to outriggers
Imprimir página
Fig. 2 Proper Safety Chain Hook Up
POSITIONING THE TRAILER/TOWER
1. Locate the Trailer/Tower unit in a place that will allow the following radius
around the tower: 70 foot radius for the T-100H & T-100UGH towers; 60 foot
radius for T-85UGH tower; 55 foot radius for the T-75H tower; and a 40 foot
radius for the T-50H tower. Mark the location (120 degrees apart) of each anchor
point (see Fig. 4). Refer to the enclosed appropriate guy wire drawing
specifications for your specific model. As an alternate, the Model GA-1 or GA-2
helical screw type guy anchors or CGA-1680 concrete type ground anchors can be
used.
2.
The tow vehicle must now be uncoupled from the unit. Remove the safety pin
and unlatch the coupler. Either swivel and lock the front tongue jack into the
useable position and crank it down so the tow vehicle can be moved away (see
Fig. 1A) OR pull the pin on the dropleg jack and allow the leg to drop to it's
lowest position. Realign the through holes and reinsert the pin. Crank it down so
the tow vehicle can be moved away (see Fig. 1B). Disconnect the safety chains,
light connector cable, and breakaway cable from the tow vehicle.
3.
Remove the two hitch pins that hold the rear "outriggers" in the stowed position.
Carefully pull them out until the second set of pinholes is visible. Then reinsert
the pins with the outriggers in the extended position (see Fig. 5). Repeat for the
front "outriggers".
2/13/2012
Fig. 3 Proper Breakaway Cable Hook Up
Fig. 4 Standard Guy Wire Anchor Points
Page 3
TRAILER TOWER SETUP INSTRUCTIONS-GUYED TO OUTRIGGERS