Cutting QG8C-A Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Cortador Cutting QG8C-A. Cutting QG8C-A 7 páginas. Power pipe cutter

Pipe Cutter Inspection

1. Make sure Power Drive is unplugged.

2. Inspect the cutter wheel to insure it is not dull, bent or damaged.

3. Check that the cutter frame rollers are free to rotate under the pipe. Clean debris, pipe

scale and dirt from rollers.

4. Ensure pipe support bearings are free to move and are clean of dirt, pipe scale and debris.

5. Check fluid levels in the hydraulic pump. Insure fluid level is to the FULL.

6. Inspect the power cord and plug for damage. If the plug has been modified, is missing the

grounding pin or if the cord is damaged, do not use the machine until the cord has been

replaced.

Work Area Set-Up

Locate a work area that has the following:

• Adequate lighting.

• No flammable liquids, vapors or dust that may ignite.

• Grounded electrical outlet.

• Clear path to the electrical outlet that does not contain any sources of heat or oil, sharp

edges or moving parts that may damage electrical cord.

• Dry place for machine and operator. Do not use the machine while standing in water.

• Level ground. Do not use on bench or elevated surface.

Using Pipe Supports

Pipe supports must be used to prevent cutter wheel damage. Failure to properly

support the pipe will result in shortened wheel life. When cutting pipe in lengths of

8"or longer, additional pipe supports must be used.

Fig 1

As shown in Figure 1 and Figure 2, the cutter and pipe supports must be positioned so that

the pipe sections have a tendency to fall away from the cutter blade as the pipe is cut. If the

Fig 2