3M 710 Manual de instrucciones - Página 17

Navegue en línea o descargue pdf Manual de instrucciones para Proyector 3M 710. 3M 710 20 páginas. Splicing rig
También para 3M 710: Folleto y especificaciones (4 páginas), Especificaciones (4 páginas)

Imprimir página

8.7 Install an index strip into the splicing rig and pull

the "T" bar to the upright position. Use the 3mm

hex wrench to insert and lightly-tighten the four (4)

screws on the handle side of the "T" bar to secure

the blade assembly and stuffer.

8.8 Pull the handle down to stop and up to release three

(3) times to seat the blade assembly and stuffer.

While the "T" bar is in the fully engaged down

position, use the 3mm hex wrench to securely

tighten all six (6) screws.

8.9 Engage the handle into the retaining clip, pull

the "T" bar up, and place into the open position.

Examine the index strip. Slight knife cuts of uniform

depth should be visible on the cutting ledge, but

not contacting the cathedral windows. If cut is not

positioned correctly repeat steps 8.1–8.9.

78-815-304--E