ALUZ A8 Series Manual - Página 7
Navegue en línea o descargue pdf Manual para Equipos de iluminación ALUZ A8 Series. ALUZ A8 Series 12 páginas. Tape
También para ALUZ A8 Series: Manual (2 páginas), Manual (14 páginas), Manual de instalación (13 páginas)
Imprimir página
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting channels.
2
Lay extrusions along chalk line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
3
Screw extrusions to surface using countersink screws.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
Extrusions aligned
4
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note: Refer to Application Guidelines to ensure correct installation.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Standard
(A8-ZIZA-STN)
Countersink hole
Countersink screw
Install lightstrip into extrusions
Remove adhesive backing
866.ALUZ.LTG | 714.535.7900
5
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
6
Install lens into extrusion, overlapping where two extrusions meet. Plan
your cuts so that the lens will always overlap where two extrusions meet.
Overlapping lenses helps keep extrusions aligned and prevents light leaks.
Two extrusions meet
7
Perform a continuity test before connecting luminaire to power source.
Page 7 of 12
Mounting Fixture
(Dry Location Mounting Channel)
Lens overlapping
Installation Instructions
4 / 11 / 2022 / Rev 1