ALUZ ZIBI A1 Series Manual - Página 7

Navegue en línea o descargue pdf Manual para Equipos de iluminación ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 13 páginas. Surface zuco pivot bios illuminated
También para ALUZ ZIBI A1 Series: Manual de instrucciones de instalación (12 páginas), Manual (11 páginas), Manual (11 páginas), Manual de instrucciones de instalación (11 páginas)

Imprimir página
1
Measure area where luminaire will be installed. Use a laser line
to create a reference along installation area, ensuring accurate
placement of mounting clips. Mark location where each mounting
clip will be installed along reference line.
2
The number of required mounting clips differs for dry and wet
location products. Verify number of mounting clips is appropriate
for installation environment before beginning installation. Do not
install luminaires with inadequate number of mounting clips. Refer
to the Mounting Clips page for additional information.
3
Lay mounting clips along reference line and pre-drill surface using
an appropriate drill bit for surface and screw size.
Recommendation: 8/32 x 1" Screw.
Note: Allow 1/4" clearance for lateral expansion of assembled
mounting clips. Only install mounting clips on flat, even surfaces.
4
If applicable, connect disconnects between luminaire segments.
Slide shrink tube over connectors and apply heat. The shrink tube
will shrink down, sealing the connectors. Apply silicone around
sealed connectors for a stronger seal.
Note: Only use a heat gun to apply heat to shrink tubes. Do not use
an open flame such as a lighter or gas torch.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
5
Screw mounting clips to surface, then snap luminaire into mounting
clips. Install set screws if required. Set screws are required for
downward and outward facing applications.
6
Perform a continuity test before connecting to power source.
Refer to Continuity Test for details.
7
Verify wiring diagram, then connect luminaire to power source.
Page 7 of 13
Wet Location Mounting
Installation Instructions
9 / 11 / 2023 / Rev 4