aion Lab Series Manual - Página 16

Navegue en línea o descargue pdf Manual para Amplificador aion Lab Series. aion Lab Series 20 páginas.
También para aion Lab Series: Manual (15 páginas), Manual (20 páginas)

Imprimir página

DRILL TEMPLATE INSTRUCTIONS

Cut out the drill template on the following page, fold the edges and tape it to the enclosure. Before

drilling, it's recommended to first use a center punch for each of the holes to help guide the drill bit.

Ensure that the template is printed at 100% or "Actual Size". You can double-check this by measuring the

scale on the printed page with a ruler or calipers.

The LEDs are sized for plain LEDs with no bezel, mounted directly to the PCB. If you don't have a 5mm

bit for the bypass and channel LEDs, use 7/32". If you don't have a 3mm bit for the limit LED, use 1/8".

Important: Due to the high number of PCB-mounted parts, it's crucial that the drilling be accurate. Since

the PCB uses slotted holes for the toggles, there's not a lot of room for error.

If the toggles don't align to the PCB, you can always drill one step larger (9/32") to allow a little more

room correct any errors. The toggle switch washer and nut will still fully cover the hole.

L5 PREAMP