Blue Angel BCPA10 Instrucciones de inicio rápido - Página 3

Navegue en línea o descargue pdf Instrucciones de inicio rápido para Instrumentos de medida Blue Angel BCPA10. Blue Angel BCPA10 13 páginas. Advanced text notification

Imprimir página

Operating Instructions and Parts Manual

GETTING TO KNOW YOUR

ADVANCED TEXT NOTIFICATION

DEVICE (FIGURE B)

1. Status Light - See page 7 for

Light Blinking Pattern Definitions

2. Low Battery Light - See page 7 for

Light Blinking Pattern Definitions

Using 3 or more batteries

may appear to work

properly even if one is inserted incorrectly.

Such usage may lead to battery leakage

or rupture that could result in equipment

damage.

Do NOT mix old and new

batteries. Doing so will

reduce overall performance and may cause

battery leakage or rupture. When replacing

batteries, always replace all 4 at the same

time.

Do NOT mix different

battery brands or types.

Doing so will reduce overall performance and

may also cause battery leakage or rupture.

We recommend using the same type of

batteries within a device.

3. PUSH TO TEST - Sends a text

notification (up to 3) to all

emergency contact phone numbers

the home owner has programmed.

4. Lower Float Water Sensor Light -

This light blinks when the bottom

float is activated.

5. Upper Float Water Sensor Light -

This light blinks when the top float

is activated.

6. Power Jack - A/C power adapter

plugs in here.

7. On/Off Switch - Turns the

Advanced Text Notification device

on or off.

8. Sensor Ports - The 2 dual

float sensors plug in here. See

(Figure B)

Figure B

Use of this device and the

ability to send and receive

texting alerts in the event of an emergency, are

contingent upon an active cellular service.

OPERATING INSTRUCTIONS

STEP 1 - VERIFY PACKAGE

UNPACKING

Inspect this device before it is used.

Occasionally, products are damaged

during shipment. If the device or

components are damaged, contact

customer service at 888-636-6628.

STEP 2

a. SIGNAL STRENGTH

b. INSTALL BATTERIES

c. NETWORK CONNECTION

a. Before installing your Advanced

Text Notification device, you will

need to check the signal strength/

reception in your basement. To do

this, plug in the A/C power adaptor,

flip the "On/Off" switch to the "On"

position and wait for the status light

to change from a red light to a

blinking green light. Blinking green

indicates you have cellular

reception, (this can take up to 1

minute).

b. Next, flip the "On/Off" switch to

the "Off" position and unplug A/C

power. Remove (4) screws, lift lid

and install (4) AAA batteries.

(Figure 1) The negative (-) end of

the battery must touch the spring.

Replace the lid and (4) screws.

Figure 1

c. Plug in A/C power adapter and flip

the "On/Off" switch to the "On"

position. Wait for the status light to

turn solid green indicating network

connection.

NOTE: If the status light remains

red, go online and check the Verizon

wireless 3G coverage map:

http://www.verizonwireless.com

www.blueangelpumps.com/AdvancedText

BCPA1

CONTENTS

Do NOT overtighten screws.