DOBE DB400 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Producto para el cuidado de mascotas DOBE DB400. DOBE DB400 9 páginas. Dog training bark collar

Imprimir página

5. Can I attach a leash to this collar?

We strongly suggest that you do NOT attach a leash to this collar.

It can result in severe injury by pushing the contact points too tightly

against a dog's neck. If you need to use a leash, attach it to a

separate and non-metallic collar or a harness while making sure

that the extra collar does not put any pressure on the contact points

on the training collar.

6. Why doesn't the device work when I test it with my hand?

When testing the collar with your hands, touch both electrodes

located at the back of the collar at the same time.

7. Why can't I feel any stimulation when the LED indicator light

is on?

Humans normally react less than dogs do. You may need to use

your fingertip to t o u c h b o t h c o n t a c t p o i n t s a n d i n c r e a s e t h e

stimulation level by adjusting the intensity dial located at the top

right corner of the remote. Make sure that both contacting points

are being touched at the same time by two fingertips.

The battery might be low. Please check the LED indicator light on

the remote and on the collar to know about the battery life span.

Make sure the toggle switch on Channel 1 or Channel 2 position

Channel A is for Anti Bark Mode. when you press one of buttons,

it is select the Anti Bark Mode.

Pairing the anti bark collar with remote again to see is it work.

If the device is fully charged and you have done all of the above,

please contact our customer service representatives to determine

whether your device needs to be serviced or repaired.

8. Is the Vibrate/Shock safe for my pet?

While the Vibrate/Shock is unpleasant, it is harmless to your pet.

Electronic training device require interaction and training from

the owner to achieve desired results.

9. Why isn't my dog reacting in Remote Training Mode?

Please make sure the device is turned on and properly paired while the

intensity levels of vibration and electrostatic pulse are not set to zero.

Make sure the collar is fitted tightly enough on the dog's neck for both

contacting points touching the dog's skin. This is very important for the

Shock Mode. If not, the Shock Stimulation will burn into your dog's neck.

The metal probes are too short to reach the dog's skin. You can replace

them with the longer ones. If the dog is still not responding after that,

please try pairing the remote and collar again or trim the dog's hair.

10. Why it doesn't work when my dog barks in Anti Bark Mode?

Make sure the Contact Points touch your dog's neck skin both. This

is very important. the anti bark collar will be identify the barks from

your dog or not by vibration. So if the barks isn't causing a vibration

against the sensor it doesn't work.

11. Why the training collar started going off randomly beep and

vibrate for no reason.

The collar is not waterproof now. Please remove the collar from your

dog , unscrew the screws, wipe out the water stains on the circuit

board and the shell. Wait for it to dry, then re-install it. most we will

fix this issue.

If still can't fix the issue, please contact our customer service

representatives to determine whether your device needs to be

serviced or repaired.

We would recommend that you have to check the rubber cover is

fully seal or not after your dog swimming.