Dobinsons BU45-3701 Manual de instalación - Página 5
Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles Dobinsons BU45-3701. Dobinsons BU45-3701 6 páginas. Bullbar for nissan navara d23 np300
Imprimir página
Please take a few clear photos
15. Ensure the bullbar mounting bracket is central
to the vehicle and as low as possible and
tighten all fasteners.
Please take a few clear photos
16. Carefully un-wrap the bulbar taking care not
to scratch it especially on the top loops.
Reinstall the number plate to the bullbar as it
is easier now. If installing driving lights to the
bullbar it is easiest to install now.
17. If not installing a winch skip to step 26.
18. See the Installation section of your Dobinsons
4x4 Winch manual for specific detailed fitting
instructions. For a brief overview see the
following steps.
19. Test fit your winch to the mounting bracket
and do up loosely with the clutch handle on
the left hand side of the vehicle.
Please take a few clear photos
20. This may require the clutch handle and gear-
box housing to be rotated forward one or 2
bolt holes to allow easy access through the
bulbar holes. See instructions in winch user
manual.
21. Determine where the winch control box will
be located and mount the control box. See
instructions in winch user manual for control
box mounting options. If mounting to the top
of the bullbar using the supplied bracket,
check clearance of control box to grill and also
check where the wires will route as if the
wires are passing through the holes in the top
of the bullbar the control box may not be able
to be wired until the bullbar has been fitted as
below.
22. Wire the winch up as per the winch
instruction manual and bolt the winch to the
mounting bracket, ensure the mounting bolts
Dobinsons Springs and Suspension
are not too long and tighten correctly. Route
the wires and connect to battery and also
route the breather hose.
23. Unwind some cable from the winch, and pass
the cable through the fairlead hole in the
bullbar and through the roller fairlead. This
may require removing a circlip from the
fairlead and re installing once the cable is
passed through.
24. Install the roller fairlead into the bulbar.
25. Check the poly bulbar over riders, fog light
and top loop bolts are tight (Do not over
tighten the stainless steel loop mounting
bolts. Do not over tighten the poly bullbar
over riders as they will pull the over riders out
of shape).
26. Wire up the lights. Using a multimeter or test
light first locate the earth wire, parker positive
and indicator positive wires from the wiring
on the back of the original vehicle lights on
each side.
27. Unclip the wiring from the indicator/parker
lights. Check that the wiring will be long
enough to reach the new bullbar
indicator/parker lights and extend if required.
Using the diagram at the end of this manual,
join the corresponding wires to original
vehicle wires located in the previous step. The
wires can be joined by either using good
quality snap lock crimp connectors or by
soldering. Ensure the connection is secure and
is sufficiently insulated.
28. If fitting a bullbar with fog lights, the fog lights
can be connected using the original vehicle
fog light wires if fitted. If required, cut the old
fog light wiring plugs off and cut the new fog
light wiring plugs and join. If the vehicle is not
fitted with OEM fog lights the wiring loom
supplied can be used. Follow the wiring
diagram at the end of this manual.
29. Install the under-headlight rubber fill in pieces
to the bullbar.
Please take a few clear photos
www.dobinsonsprings.com